How to install and pretreat high temperature mesh belt?

6 steps to install the mesh belt

1. Before installation, make sure the sintering furnace has been turned off and cooled, and clean the installation area of ​​debris and dust.
2. Check the new mesh belt for damage, deformation or defects. If the old mesh belt is seriously damaged, pay more attention when cutting and replacing it.
3. Fix the starting end of the mesh belt on the driving wheel or driven wheel of the sintering furnace to ensure it is firmly installed.
4. Gradually unfold the mesh belt along the track inside the furnace body, paying attention to keeping the mesh belt flat to avoid twisting and folding.

  5. Fix the ends of the mesh belt on the corresponding wheels and adjust the tension so that it is moderately tight but not too tight.

  6. After installation, carefully check whether the mesh belt is installed correctly and whether there is any deviation or looseness.

6 steps of using preprocessing

1. Before use, preheat the sintering furnace so that the temperature inside the furnace reaches the operating temperature range.

2. Material placement: Place the powder metallurgy materials to be sintered evenly on the mesh belt to avoid material accumulation or uneven distribution.

3.Control speed: According to the process requirements, adjust the running speed of the mesh belt to ensure that the sintering time and temperature of the material in the furnace are appropriate.

4.Temperature monitoring: Closely monitor the temperature inside the furnace to ensure that the temperature is stable within the set range

5.Regular inspection: During use, regularly check the running condition of the mesh belt, such as deviation, wear, etc.

6.Maintenance: After use, clean the residue on the mesh belt in time and maintain the mesh belt to extend its service life.